I fixed my issue by flashing the latest Beta BIOS for my motherboard. Took me almost a full day of troubleshooting and looking online and repeating the same steps over and over again, but then almost on a whim I decided on flashing the Beta BIOS (no mentions of virtualization in the changelog, so I didn’t really have reaaons to) and now Android Studio finally simulates the Android device. Thanks for your help!

I get the same exact error via Flatpak and “the user … is already a member of kvm”, unfortunately.

Thanks anyway!

Thanks for the reply and the testing. It’s not via Flatpak (I figured it would be best not to, since Flatpak Gnome Boxes could not create a VM because of KVM issues, while Boxes installed via sudo apt install gnome-boxes gave me no error), but a simple tar extracted in desktop.

Since AMD Virtualization is Enabled in BIOS (although I can’t toggle it) and Gnome Boxes can create a VM when installed via terminal, I don’t think it’s a BIOS or CPU problem (otherwise no version of Boxes would allow me to run a VM, but I did launch Arch btw from inside Boxes).

Am I wrong?

Thanks!

Apparently PoP! doesn’t support Secure Boot. No idea why the system still runs and works apart from loading nVidia drivers though

Issue found: I disabled secure boot from BIOS and now I can change resolution and refresh rate. Thanks for the help!

Issue found: I disabled secure boot from BIOS and now I can change resolution and refresh rate. Thanks for the help!

Checked it just now and yes it’s properly seated. Checked power cables too and those are good as well. Cleared CMOS and now display defaults to 1024*768 resolution with no way to change it lol

Teach me your ways. I don’t have a very new model, I think it’s a 4130e or something. Do you use CUPS?

My issue lies elsewhere, it takes me that long to have the printer recognized by the OS, then by CUPS browser, then I send the printing job and… it just stalls, never prints. I then cycle the USB ports and start all over again until it miraculously prints

I have a HP printer and printing is never a smooth process. No idea why, but it takes me 5/10 minutes each time